Bay Networks Remote Annex 4000, Hardware Installation Manual

Page: 55 / 162

2-17 Remote Annex 4000 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 4000
3 Set the Remote Annex 4000 to Test Mode.
Pressing the Test button within 3 seconds of
powering up puts the Remote Annex 4000 into
test mode. To enter test mode when the Annex is
already running, hold down the Test button until
the Power LED blinks rapidly, then release the
Test
button and press it again within 3 seconds.
This second method resets the Remote Annex, so
warn users before you do it.
Press the Test button located on the Remote Annex 4000 front
panel. The Test LED lights when the unit enters Test Mode (see
Figure 2-19).
Figure 2-16. Setting the Remote Annex 4000 to Test Mode
Next, the Remote Annex 4000 runs diagnostic tests, causing the
Active
LED to flash. If the diagnostics complete successfully, the
Unit , Net, and Attn LEDs light. If a terminal is connected to the
console port, the ROM Monitor prompt appears on the terminal.
STATUS
POWER UNIT NET ATTN LOAD ACTIVE 1 2 3 4 5 6 7 8
TEST
Test Button