baxter Flo-Gard 6301, Service Manual, Page: 97 / 252

07-19-B1-729 FLO-GARD 6301 DUAL CHANNEL VOLUMETRIC INFUSION PUMP SERVICE MANUAL
8-23
Removal/Replacement Procedures Disassembly/Reassembly
1.
Open the pump door and insert the Slide Clamp Resetting Tool into the
slide clamp mechanism until it stops (this tool cannot be pushed in fully).
2.
Press the safety clamp pin to release the slide mechanism. This pushes
out the tool slightly.
3.
Carefully remove the tool. When the slide clamp mechanism is activated
properly, the ridges on both sides of the tool should rub against the claws
of the mechanism.
4.
Insert the spring retainer until it locks in place.
Replacement of Back Plate
1.
Remove the pump door cover in accordance with “Replacement of Pump
Head Door Cover” on page 8-9.
2.
Remove the back plate cover (Figure 11-5 or Figure 11-10 , item 16) by
removing the screw inside the door (item 27).
Note: Perform the following step carefully to avoid losing springs (Figure 11-5 or
Figure 11-10 , item 18).
3.
Remove the 7 screws (Figure 11-5 or Figure 11-10 , item 26) from the
outside of the door.
4.
Remove the 5 springs (Figure 11-5 or Figure 11-10 , item 18) and the
back plate (Figure 11-5 or Figure 11-10 , item 17).
5.
Install the replacement back plate.
Q
Ensure that the back plate is clean and not worn.
Q
Ensure that the notch in the back plate aligns with the tongue in the
door.
Q
Ensure that all 5 springs (Figure 11-5 or Figure 11-10 , item 18) are
in place and perpendicular to the back plate cover.
6.
Install the back plate cover (Figure 11-5 or Figure 11-10 , item 16) in
reverse order.
7.
Apply pressure to the back plate cover and install the screws
(Figure 11-5 or Figure 11-10 , items 26 and 27) working from the
outside edges to the center. That is, install the top and bottom corner
screws first, followed by the screws in the center of the back plate cover.
8.
Press the back plate a few times from the inside of the door to ensure
smooth operation.
9.
Tighten the screws to 6 kgf-cm (5.2 in-lb).