baxter Flo-Gard 6301, Service Manual, Page: 22 / 252

2
Controls and Indicators
2-2
FLO-GARD 6301 DUAL CHANNEL VOLUMETRIC INFUSION PUMP SERVICE MANUAL 07-19-B1-729
Controls and Indicators
All controls and indicators are described in the following sections and are
shown in Figure 2-1, Figure 2-2, and Figure 2-3. Service personnel should
be familiar with the pump’s features and operation before servicing the
device. When the word “device” is used in this manual, it refers to the entire
FLO-GARD 6301 Dual Channel Volumetric Infusion Pump. Generally, the
word “pump” is used to refer to either Pump 1 or Pump 2.
Each device’s serial number is recorded on a label on the back of the device.
Power Cord 2.75 m (9.0 ft.) long, with hospital grade plug
Leakage Current Typically less than 50 μ A (using UL-544 specified test methods)
Power Consumption 50 W
Weight 8.2 kg (18 lbs)
Dimensions 33 cm W x 13 cm D x 29 cm H (13" W x 5.1" D x 11.4" H)
Flow Rate Range Primary program: 1 - 1999 mL/hr in 1 mL/hr increments and
1 - 99.9 mL/hr in 0.1 mL/hr increments. Upper limit can be reduced by
authorized service personnel.
Secondary program: 1 - 999 mL/hr in 1 mL/hr increments and
1 - 99.9 mL/hr in 0.1 mL/hr increments.
VTBI Range 1 - 9999 mL in 1 mL increments and 1 - 99.9 in 0.1 mL increments for both
primary and secondary. Upper limit can be reduced by authorized service
personnel.
Air-in-Line Detection Factory set to NORM that causes the device to alarm on air bubbles
approximately 75 μ L or larger. The MIN setting causes the pump to alarm on
bubbles approximately 50 μ L or larger.
Fuse 0.5 A Slo-Blo
Nurse Call 9-pin D connector, Pin 1: N/O, Pin 4: N/C, Pin 9: Common
Contact rating: 0.4A at 30 VAC, 2A at 30 VDC resistive load (internal
activation required)
Item Characteristic