baxter Flo-Gard 6301, Service Manual, Page: 104 / 252

8
Disassembly/Reassembly
8-30
FLO-GARD 6301 DUAL CHANNEL VOLUMETRIC INFUSION PUMP SERVICE MANUAL 07-19-B1-729
6.
Install replacement battery in reverse order.
7.
Verify that the configuration option is set as desired and modify if
necessary (See “Modifying the Configuration Option Settings” on page
5-2).
8.
Perform the Operational Checkout in Chapter 10, “Operational
Checkout”.
Tube Guide Shim Installation
Required Parts:
Q
Air Sensor Tubing guide shim (part no. 722003396)
Q
Loctite Prism 454 adhesive (part no. 722003397)
Q
Cellophane tape
Note: Open the pump head door and check for a white tubing guide shim or a letter
“A” on the door, opposite the air sensor.
W hen the shim or letter “A” is
present, it is NOT necessary to perform this procedure.
Perform the following procedure for Pump 1 and Pump 2.
1.
Clean the tube guide area on the door with a small paint brush soaked in
a solution of dishwashing detergent and rinse with clean water.
2.
Use an air source that is free of oil to dry the tube guide or allow it to air
dry.
3.
Lay the pump on its side opposite the pump head.
4.
Place the tube guide shim on the tube guide and note the surfaces making
contact with the tubing guide for adhesive application. To handle the
shim, press a 3-inch piece of cellophane tape onto the shim lengthwise.
Use the tape to lift the shim from the door. Save the tape and shim
combination.
5.
Use the applicator on the tube to apply a thin, uniform layer of Loctite
Prism 454 adhesive to the tube guide surfaces to which the shim is to be
bonded. To achieve a good bond you must apply adhesive to all of the
shaded areas (see Figure 8-3).
! WARNING !
Make sure the pump is not plugged into AC power.