baxter Colleague 3 CXE, Operator'S Manual

Page: 101 / 230

071960491 COLLEAGUE CXE VOLUMETRIC INFUSION PUMP OPERATOR’S MANUAL
4-47
Operating Instructions
Secondary Infusions
The Secondary Rate-Volume Programming screen is displayed,
including the secondary icon (Figure 4-68). The
Rate
field is
highlighted.
2.
Enter the secondary flow rate using the numeric keypad.
3.
Press the
Vol
key or use the
×Ø
keys to highlight the
Volume to be
infused
field.
4.
Enter the
Volume to be infused
using the keypad.
5.
When all infusion parameters have been entered, verify that:
„
pump programming matches the label on the source container and
the physician’s order
„
the loaded administration set is connected to the correct source
container and administration route for the programmed infusion
6.
Press the
Confirm Secondary
soft key.
7.
If the primary set has a regulating clamp above the pump, close the
regulating clamp. Open the On/Off clamp on the secondary
medication/solution set and press the
START
key.
If a primary infusion has been programmed but not confirmed, an
Unconfirmed Primary Program
alarm occurs and a message is
displayed on the prompt line. Complete the following:
„
Press the
Primary
soft key to review the primary infusion
program. For more information about primary infusions, see
“Primary Infusions,” 4-21
„
Press the
Confirm Primary
soft key.
Figure 4-68 Secondary
Programming Screen
! WARNING !
There may be periods of no flow for flow rates less than
or equal to 1mL/hr.
! WARNING !
Do not enter a Volume to be infused greater than the
amount of fluid available in the container.
Note:
Optional Labels
An optional label may also be selected. See “Selecting
a Label” on page 4-23 for details.
Note:
Unconfirmed
Secondary
Program
If the START key is pressed before pressing the
Confirm Secondary soft key, an
Unconfirmed
Secondary Program
alarm occurs and a message is
displayed on the prompt line.