is specifically excluded from the guarantee.
To replace the light bulb.
1.
To gain access to the light bulb, remove the top coal fuel effect and place carefully to
one side.
2.
Unscrew and remove the decorative control knob from the front of the ‘ash pan’
casting (See figure 12). Remove the ‘ash pan’ casting.
3.
Swing the bottom of the firefront casting forward and down. Gently pull the casting
away from the heater (Reverse of that shown in figure 11).
4.
Replace the light bulb with 60Watt max, BC Clear, 16,000Hr (GLS) Bayonet, 240V
lamp.
5.
Refit the firefront / ‘ash pan’ and top fuel effect.
2. My heater is on but there is no light or heat.
The first thing to do is check the wall socket. To do this plug in a known working
appliance. If the appliance you have plugged in works then there is a good chance that
the problem lies with the 13Amp fuse in the heater plug. If either fuse or socket is
suspected, have them checked by an electrician.
3. My heater is on but there is no heat.
A cut out device is fitted to the heater to prevent damage due to over heating. If it
operates due to an obstruction in the airflow, the heater must be turned off and allowed
to cool for 15 minutes and the obstruction removed before restarting.
4. I Have a problem that is different to those in the previous examples 1- 3.
Following is a list of useful telephone numbers
For general advice about your heater:
BAXI FIRES DIVISION TECHNICAL HELPLINE 08706 061 065.
To report faults or arrange for your heater to be serviced:
BAXI FIRES DIVISION SERVICE 08706 090 081.
For sales or product information:
BAXI FIRES DIVISION SALES 08706 061 067.
CALLERS IN THE REPUBLIC OF IRELAND
Call 0044 8706 061 065
For spares inquiries
Spare parts are available nationwide via the ‘interpart stockist network’. For your
local stockist consult Yellow pages under ‘Central Heating’.
Page 13
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2006.