Syscompact 2000 M pro
Configuring and operating the IRG 2000
822-175-2
43 / 98
The IRG 2000 time domain reflectometer can be used to carry out the following tasks:
Performing the TDR measurement
Setting measurement parameters for cable fault location
Starting and stopping the recording of measurement data
Evaluating traces
9.1 Turning on the IRG 2000
Press the
key on the IRG 2000 for approx. 2 seconds.
If the Syscompact 2000 M pro is not switched on, the IRG 2000 runs in battery-operated
mode. The status LED is off.
If the Syscompact 2000 M pro is switched on, the IRG 2000 runs on mains operation
mode. The status LED is illuminated green.
9.2 Selecting the language
>
System
>
Language
1. Press the
MENU
key.
2. Use the rotary knob to select the
System
menu item and press the rotary knob.
3. Use the rotary knob to select the
Language
menu item and press the rotary knob.
4. Use the rotary knob to select the desired language and press the rotary knob.
The user interface of the IRG 2000 is displayed in the selected language.
9.3 Setting the date and time
If you save the measurement data, they are automatically saved under a name comprising the
date and time.
>
System
>
Date / Time
1. Press the
MENU
key.
2. Use the rotary knob to select the
System
menu item and press the rotary knob.
3. Use the rotary knob to select the
Date / Time
menu item and press the rotary knob.
4. Set the date and time using the rotary knob.
5. To save the settings, turn the rotary knob until the
OK
button is selected, then press the
rotary knob.
9
C
ONFIGURING AND OPERATING THE
IRG
2000
Summary of Contents for Sys compact 2000 M pro
Page 97: ......
