Baur PD-TaD 80, User Manual, Page: 37 / 74

PD-TaD 80 Connecting the system
822-188-3 37 / 74
No. Cable Step
8 HV connection cable of
the cable test van (on
cable drum rack) Connect the HV connection cable to the DU 80 discharge unit.
– –
Guide all connected cables through the cable outlet of the rear door and
close the rear door.
At the PD-TaD 80:
9 Short-circuit cable of
PD-TaD 80 On the PD-TaD 80, remove the short-circuit cable from ports HV IN and
HV OUT .
At the far end of the test object:
10
–
Clean the cable termination of the phase to be tested carefully.
11
–
Attach the anti-corona hoods of the anti-corona protection device to the
cable termination of the phase to be tested.
At the near end of the test object:
12
–
Clean the cable termination of the phase to be tested carefully.
13
–
Attach the anti-corona hoods of the anti-corona protection device to the
cable termination of the phase to be tested.
14 HV connection cable of
PD-TaD 80 Connect the PD-TaD 80 ( HV OUT port) to the phase to be tested.
To do this, select the shorter of the two supplied HV connection cables.
Place the HV connection cable as far away as possible from the adjacent
live and earthed parts.
At the near and far end of the test object:
15
–
Remove the earthing and short-circuit connection from the phase to be
tested.
Make sure that the phases not being tested are earthed and short-circuited.
6.10.2 Connecting the system to the PHG 70/80 portable VLF HV generator
Prerequisites

The workplace must be de-energised, earthed and short-circuited.
Further information: Chapter Ensuring there is no voltage at the work place (on page 32)

The connection points and far end are prepared for the measurement tasks.
Further information: Chapter Preparing the test object terminals (on page 32)

HV coupling unit of PD-TaD and the cable terminations of the test object are clean and
dry.
Further information: Chapter Cleaning the PD-TaD 80 and system components (on page
60)