Baur PD-TaD 62, User Manual, Page: 31 / 114

PD-TaD 62 Connecting the system
822-187-3 31 / 114

Please consider the following provisions and guidelines when installing the testing
system and operating the BAUR testing and diagnostic systems:

Accident prevention and environmental protection regulations applicable for your
country

Safety instructions and regulations of the country where the system is being used
(according to the latest version)

EU/EFTA countries: EN 50191 Erection and operation of electrical test equipment
Other countries: The standard for erection and operation of electric test equipment
applicable for your country

EU/EFTA countries: EN 50110 Operation of electrical installations
Other countries: The standards for operating electric systems applicable in your
country

If necessary, other national and international standards and guidelines in the latest
applicable version

Local safety and accident prevention regulations
 Employers’ liability insurance association regulations (if any)

Use the personal protective equipment for protection against electric shock and burning
due to possible arcing faults in compliance with the local work safety and accident
prevention regulations.
6.1 Specific safety instructions
WARNING
High electric voltage through potential increase
A fault can cause flashovers in the device. In this case, a potential
increase of the housing is possible due to high short-circuit currents.
Danger due to the potential increase is reduced when a protective
earthing is connected properly.

Connect the protective earthing carefully. The protective earthing
cable should be as short as possible and of low impedance.
6 C
ONNECTING THE SYSTEM