37
Instruction handbook BUM 60 / BUS 60
Document No.: 5.01032.05
6
M
OUNTING
In this chapter we describe the mechanical mounting of the device into a control cabinet.
Mounting consists of the following steps:
1 Prepare mounting (drill holes/cut-out segments)
2 Install device
6.1
Safety notes
NOTE!
Mounting shall only be performed by employees of the manufacturer or by other qual-
ified personnel.
Qualified personnel are persons who – on account of their occupational training, ex-
perience, instruction and knowledge of relevant standards and stipulations, accident
prevention regulations and operating conditions – are authorized by the persons re-
sponsible for the safety of the facilities to perform the respective activities that are
necessary, while at the same time recognizing and preventing any potential risks.
The qualifications necessary for working with the device are, for example:
m
Occupational training or instruction in accordance with the standards of safety en-
gineering for the care and use of appropriate safety equipment.
