Safety
Instruction handbook BUM 60 / BUS 60
Document No.: 5.01032.05
13
2
2.4
Responsibility of the operating company
The device will be used in commercial areas. Thus, the proprietor of the device is subject to the
legal work safety regulations.
Along with the notes on work safety in these instruction handbook, the safety, accident preven-
tion and environmental protection regulations valid for the area of application of this device must
be complied with. Whereby:
m
The operating company must inform himself about the applicable work health and safety reg-
ulations and ascertain, in a hazard assessment, any additional hazards that could arise from
the special working conditions in the use area of the device. These must then be implemented
in the form of instruction handbook for operation of the device.
m
These instruction handbook must be kept accessible to personnel working with the device at
all times in the immediate vicinity of the device.
m
The specifications of the instruction handbook must be adhered to completely and without ex-
ception.
m
The device may only be operated in a technically faultless and operationally safe condition.
2.5
Protective devices
The devices BUM 60 / BUS 60 comply with the protection class IP 20.
All devices BUM 60 / BUS 60 must be installed in an appropriate control cabinet to meet the
protection classification required in EN 61800-5-1, chapter 4.2.3.3.
DANGER!
Risk of fatal injury from electrical current!
There is an immediate risk of fatal injury if live electrical parts are contacted.
Therefore:
m
The device must be in operated inside of a control cabinet that provides protection
against direct contact of the devices and at least meets the requirements of
EN 61800-5-1, Chapter 4.2.3.3.
