
WARNING!
Danger of injury due to uncontrollable behavior of the machine/line.
The behavior of the machine/line can change as a result of removing the component
assembly with the power source connected.
Therefore:
m
Make sure that the power to all electrical connections is shut off and secured to
prevent from being turned back on.
m
Using suitable measuring equipment check, to make sure, that none of the
connections are carrying live current before beginning work on the electrical
connections.
m
Only disassemble the connections and remove the connection once you are
completely certain that the component assembly is not under power.
m
Hanging loads could disconnect unexpectedly and fall, because STO is enabled
during the removing of the assembly group.
Requirements on the personnel conducting the work
Operation Manual
Safety Module for b maXX 5000
BM5-O-SAF-002/3
Document no.: 5.11016.03
Baumüller Nürnberg GmbH
152
23.2
23.2 Requirements on the personnel conducting the work
The personnel, who is assigned to carry out the disassembly must have the knowledge
and training, which is necessary to perform this work properly. The personnel must be
able to understand and use the safety instructions attached to the device and its
components as well as the connections.
23.3 Disassembly
The personnel carrying out the disassembly must meet the requirements above.
Carry out the disassembly process in the following order:
1
Make sure that the power has been disconnected and cannot be turned back on
accidentally.
2
Disassemble the Safety Module in the reverse order of the assembly (see chapter
3
Document the disassembly (or replacement) of the Safety Module.
4
Document the disassembly (or replacement) of the controller, if applicable.
5
Document the disassembly (or replacement) of the additional system components, if
applicable.
23.4 Storage conditions
Store the Safety Module in a adequate package with regard to the storage conditions
specified in the
Summary of Contents for BM5-O-SAF-002
Page 181: ......