Baumuller BM4-O-CAN-06, Operating Instructions Manual, Page: 34 / 60

Commissioning sequence
Operating Instructions CANsync-Master Option Module for BM4-O-PLC BM4-O-CAN-06
Document No.: 5.02056.01A
Baumüller Nürnberg Electronic GmbH & Co. KG
32
von 56
6.5
To find out how to eliminate the cause of the error, refer to Z Finding and eliminating dis-
turbances – from page 35 onward.
6.5 Commissioning sequence
Commissioning is divided into the following procedures:
1 Activation.
2 Testing the function.
6.5.1 Activation.
m Read and observe the Z General safety regulations – from page 29 onward.
m You must have carried out correctly section "Assembly and Installation".
m Switch on the b maXX 4400 basic unit.
6.5.2 Testing the function
After activation, the LEDs flash one after the other (as described in Z Activating and ini-
tializing – on page 31).
If a complete application is present, LED H1 then shows receiving and sending of mes-
sage frames on the CANsync bus.
NOTE
You must not remove or plug in the CANsync-Master option module while the b maXX 4400
basic unit is switched on. Switch the unit off first.