Requirements on the personnel carrying out the work
Operation Manual
b maXX safe PLC
BMC-M-SAF-02
Document no.: 5.07020.04
Baumüller Nürnberg GmbH
94
17.2
17.2 Requirements on the personnel carrying out the work
The personnel you assign to carry out the disassembly must have the knowledge and
training necessary to perform this work properly. The personnel should be selected so
that it will be able to understand and use the safety instructions attached to the device
and its components as well as the connections.
17.3 Disassembly
The personnel carrying out the disassembly must meet the requirements above.
The b maXX safe PLC is assembled together with the power supply for the b maXX con-
troller/safe PLC and any further system components for the b maXX safe PLC.
In the disassembly process, the b maXX safe PLC and the power supply as well as any
further system components for the b maXX safe PLC are detached from the 35 mm C-
rails (and the I/O modules attached to the right on the power supply).
The b maXX safe PLC is then removed from the power supply.
The following equipment will be needed:
m
Suitable packaging for the b maXX safe PLC; use the original packaging if possible.
m
Suitable packaging for the power supply module for the b maXX controller/safe PLC (if
applicable); use the original packaging if possible.
m
Suitable packaging for further system components for the b maXX safe PLC (if appli-
cable); use the original packaging if possible.
m
A suitable tool to open the spring clamps of the electrical connects (such as a screw-
driver with a 2mm wide blade).
m
A suitable tool for pulling out the white handles on the bottom of the module (such as
a pair of needlenose pliers for electronic work).
Carry out the disassembly process in the following order:
1
Make sure that the power has been disconnected and cannot be turned back on acci-
dentally.
2
Open the electrical cabinet.
3
Remove the cables to the electrical connections.
To do this, disengage the spring clamps (with a screwdriver, for instance) and pull out
the respective cable.
4
Remove the cables to the b maXX safe PLC
5
Remove the cables to further system components (if applicable) which are attached
to the b maXX safe PLC (for more on this, see the respective operation manuals for
the system components in question).
6
There is a white handle on the bottom of the left part of the power supply. Pull this han-
dle downward and then to the left (with a pair of needlenose pliers for electronic work,
for instance). The handle will engage easily.
Repeat this step for the b maXX safe PLC (3 handles with the BMC-M-SAF-02; 4 han-
dles with the BMC-M-SAF-02 with storage card module).
Repeat this step for further system components (if applicable) for the b maXX safe
PLC (which are plugged in on the left side of the power supply or of the b maXX safe
PLC)
Summary of Contents for b maXX BMC-M-SAF-02
Page 119: ......
