Baumuller b maXX BM5800, Parameter Manual

Page: 320 / 816

Management
Parameter manual b maXX BM5800
Document No.: 5.16029.03 Baumüller Nürnberg GmbH
320
of 814
3.5
3.5.2.8 Functions of the Data Set Management System
Data Set Manage-
ment

Commands
The Data Set Management System has the following functions

(can be set in
Z
105.1
–
Command):
m
Reset the Data Set Management System
m
Write parameter set to Flash memory
m
Read parameter set from Flash memory
m
Delete parameter set in Flash memory
m
Set standard values for the active data set
m
Set standard values for the axis specific parameters of an axis
m
Set standard values for all savable parameters
m
Create Data Set <n>
m
Delete Data Set <n>
m
Copy Data Set <x> to Data Set <y> (from RAM to RAM)
m
Load Data Set <x> from Flash memory
Status of the Data
Set Management
System The status parameter
Z
105.2
–
Data Set Management Status is used to display the result:
m
Error while writing (incorrect value, parameter write-protected, invalid parameter num-
ber)
m
Error while reading
m
Command processing running
m
Error code
Some commands for data set management require additional parameters, which are list-
ed as follows:
m Z
105.8
–
Source Data Set

Source data set for certain commands such as "Copy" or "Reload".
m Z
105.9
–
Target Data Set

Target data set for certain commands such as "Create" or "Delete".
m Z
105.6
–
Active Data Set Number

The number of the active data set is shown here. Writing to this parameter effects an
immediate change of data set.
m Z
105.3
–
Message Text

Array with 20 entries

Displays the number of the parameter for which an error occurred with the last data set
command. If an error occurs during command processing, the command does not in-
terrupt the transfer procedure but instead continues the transfer procedure with the
next parameter.
m Z
105.5
–
Data Set Identification Number

Unique ID number for the data set stored in Flash memory
m Z
105.4
–
Data Set Name

The name of the active data set (string) can be freely assigned by the user.
NOTE!
The drive must be switched inactive during loading of the data sets.