20 Ton Electric Log Splitter
E&OE
©2018 Bäumr-AG
6
Equipment Safety
Log splitting machines produce high hydraulic pressures and have exposed parts that can
cause serious injury if not used correctly or without taking proper safety precautions.
It is
extremely important that you read and fully understand the information in this section and all other
safety warnings / recommendations and usage instructions before using the equipment
.
Operator
•
If you are untrained in the use of a log splitter, it is highly recommended that you be trained/instructed by
a suitably qualified or experienced person before using the machine.
•
Fully understand how to safely operate the machine and the log splitting process. See Log Splitter
•
The machine must be operated by one person only.
•
You must be in good physical condition to use a motorised cultivator. NEVER operate the machine when
tired, or under the influence of any substance (medication, alcohol, drugs etc) that may impair your
judgement, alertness, physical strength, vision or dexterity.
•
Crush / amputation hazard - keep hands away from moving parts and from splits/cracks that open in
logs.
•
Maintain sure-footing and balance always when using or handling the machine and have full awareness
of your surroundings and any possible hazards.
Clothing and Protective Equipment – All Operators and Assistants
•
Wear approved safety goggles, or safety glasses with adequate top and side protection..
•
Wear suitable hearing protection.
•
Wear heavy-duty, non-slip leather or protective gloves.
•
Wear approved heavy-duty safety boots, with steel toe-caps and non-slip soles.
•
Wear suitable overalls or work clothing that fits snugly, but does not restrict movement. Avoid loose
fitting clothing, scarves, jewellery etc and keep long hair contained to avoid getting caught or pulled by
the chainsaw or by tree branches etc.
Work Area Safety
•
Do not allow helpers or bystanders within 30m (90') of the machine. Bystanders should wear eye
protection.
•
Do NOT use in wet conditions.
•
Ensure that the work area is dry, level and firm enough to adequately support the machine.
Operational Safety
•
Do NOT use the machine if the control lever or any safety guard or mechanism is not installed or is not
operating correctly – have the machine inspected and repaired at an authorised service centre before
using it again.
•
Do not load or unload logs whilst the ram is moving.
•
Do not remove jammed logs by hand.
•
Make sure there are no nails or foreign objects in the logs to be split.
•
Log ends must be cut square.
•
Branches must be cut off flush with the trunk.
•
Always split logs in the direction of the wood grain.
•
Do NOT use the equipment for purposes it is not designed for, such as splitting non-wood material.
•
Do not attach the machine to fixed supports.
