E&OE
© 2020 Baumr-AG
42
Accessories
A range of accessories is available from your versatility of your machine. These are as follows:
44. Independent 4-Jaw Chuck 80mm dia.
45. Face Plate - 160mm dia.
46. Moving Steady
47. Fixed Steady
48. Tailstock Drilling Chuck with a 13 mm capacity
49. Headstock Centre (MT3)
50. Revolving Centre (Tailstock - MT2)
51. 6 Piece Cutting Tool Set Comprising tools for 60 thread cutting, parting/grooving, facing and general turning
work (Hex wrench not shown).
52. Thread Dial indicator (not shown) (Imperial or Metric)
External Jaws
– 3-Jaw Chuck
To change the jaws, insert the chuck key and open the jaws to their
fullest extent. It will then be possible to remove each jaw in turn.
Replace them with the external jaws, noting the following:
•
The thread segments of the jaws are progressively 'stepped' as
shown in Fig. 14. They are also numbered 1 to 3. This is to
consider the lead of the screw thread within the chuck. It is
therefore necessary to assemble the jaws in the correct order.
•
Place them as shown in Fig. 14, and assemble in the same
order, clockwise in the slots in the chuck, turning the chuck key
as you insert them. Close the jaws fully and check to ensure
