Positioning
The adjacent furniture must be able to withstand a
minimum temperature rise of 85°C above the ambient
temperature of the room it is located in, during
periods of use.
This appliance is classified as Class 3 and therefore is to be built into a
kitchen unit (depending on size) or 600 mm worktop that is at least 30
mm thick. The following minimum clearance distances must be
observed:-
o
700 mm between the hob surface and the underside of any
horizontal surface above it.
o
50 mm clearance around the sides and front of the appliance,
measured from the cut out.
o
55 mm clearance between the back of the hob surface and the
wall behind it, measured from the cut out.
o
If the hob is positioned so that the right or left hand side of the
appliance will be near to the edge of a kitchen unit. There must
be a gap of at least 150 mm between the side of the hob and the
vertical surface of the kitchen unit.
25
of
the hob.
o
IMPORTANT:
Underneath
the appliance there must be
a partition made of insulating
material (e.g. wood). There
must be a gap of at least 50
mm between the underneath
of the appliance and this
partition.
o
You must make sure that
there is a 5mm gap below
the underneath of the
worktop at the front edge
Summary of Contents for BHI645SS
Page 1: ...1 BHI645SS 60cm Induction hob ...
Page 33: ...33 ...
Page 34: ...34 ...
Page 36: ...36 ...
