26
o
The brass links must be positioned as marked in the appropriate
diagram and once established ALL terminal screws must be
tightened down firmly.
o
nes
eck that the terminal screws are all
fully tightened between the links. This should be done
o
ot
must be
taken to avoid the cable being in contact with hot parts of the
Repla
If the mains supply cable is damaged, then it must be replaced by an
obtained from the Baumatic
pares Department.
o
Open the terminal block on the underside of the hob.
o
Unscrew the terminal screws fixing the cable.
o
Replace the cable with one of the same length and in accordance
If when the hob is first switched on, only two of the zo
work, you should rech
before contacting the Baumatic Service Department.
IMPORTANT: The appliance must NOT be connected to the
mains supply by means of a 13A plug and socket.
o
The cable can be looped if necessary, but make sure that is n
kinked or trapped when the hob is in position. Care
appliance.
cing the mains supply cable
appropriate replacement which can be
S
The mains supply cable should be replaced in accordance with the
following instructions:
o
Switch the appliance off at the control switch.
with the specification given above.
Summary of Contents for BF18SS
Page 1: ...1 BF18SS 77cm touch control ceramic hob...
Page 31: ...31...
