Baumalight GXM350, Operator'S Manual, Page: 19 / 24

^
WARNING
Prevent serious injury or death caused
by unexpected movement:
1�
Park excavator on a level surface�
2�
Engage excavator parking brake�
3�
Disengage hydraulic drive�
4�
Shut off engine and remove key.
^
WARNING
Drilling, sawing, sanding or machining
wood products can expose you to wood
dust, a substance known to the State of
California to cause cancer�
Avoid inhaling wood dust or use a dust
mask or other safeguards for personal
protection� For more information go to
www�P65Warnings�ca�gov/wood�
^
WARNING
Wear an approved dust mask or
respirator�
Follow local, state and federal
regulations�
1. Park excavator and grinder on a level surface.
2. Lower grinder to the ground.
3. Shut off engine and remove key.
4. Inspect cutting teeth (A) for damage and wear.
Replace individual teeth as needed.
5. Remove locknut, spacer and tooth. Install new
tooth. Flat shoulder (B) on tooth will fit against
shoulder (C) on tooth holder.
6. Install spacer and locknut.Tighten locknut to
65 lb/ft (88 Nm) of torque.
5�2 Replace Cutting Teeth
Note: Parts breakdown can be found on
Baumalight’s website.
www.baumalight.com
17