Attach to your desk
(mounting to edge of desk)
Attach to your desk
(mounting to desk cable opening)
Have you got everything?
Unpack the box (be gentle) and make sure all of these items are there:
Attach the clamp to the base with the 3 flat cap
screws. Use the 4mm hex key to tighten.
Loosen the two screws that connect the two parts of
the clamp.
Adhere the mounting plate bolt cover to the
base and adhere the bracket clamp cover to the
support block.
Put the arm through the hole in your table.
Tighten the securing bracket by turning the adjuster
clockwise and make sure it’s tight. If your desk is too
thick, adjust the clamp down a notch and re-tighten.
Install the lower part of the
clamp with the two screws.
Tighten the clamp until it is
securely fastened to the desk.
Nearly done!
Just a bit more
on the other side
of this page...
A. Bracket
B. Bracket clamp
C. M4 x 8mm screws (x4)
D. M4 x 16mm screws (x4)
E. Screw spacers (x4)
F. 4mm hex key
G. 5mm hex key
H. Cap screws (x3)
I. Bracket clamp cover
J. Bracket cover
K. Mounting plate bolt cover
L. Cable cover
M. Warranty Card
N. Quick Start Guide
You will also need
a Phillips-head
screwdriver
to secure your
monitors to the
bracket
Hey!
Let’s get your new monitor
bracket ready to use, fast!
Quick Start Guide
Model: AMAB-0619-S
M
N
H
I
L
F
J
K
1
1
2
3
2
3
Be careful not to overtighten the clamp or you might cause
surface damage to your desk or table
