Page 11
For technical questions, please call 1-888-866-5797.
Item 64995
Sa
FE
ty
Op
E
ra
ti
O
n
Maint
E
nanc
E
S
E
tup
Edger Operation
1. Remove Battery Pack.
2. Place the Wheel Assembly in the proper
position for edging operation. Refer to
Edger Wheel Setup
on page 8.
3. Pull up on the Angle Lock, rotate Handle/
Upper Shaft clockwise 90 º and release Angle
Lock. The Upper Shaft will click into place.
4. Adjust Auxiliary Handle as necessary.
Loosen Auxiliary Handle Lock Knob and
move Handle to desired position. Tighten
Lock Knob securely after adjustment.
5. Adjust length as necessary by turning
Extension Lock clockwise, pulling Extension
Tube out to desired length, then turning
Extension Lock counterclockwise securely.
6. Adjust head angle by rotating the Head Angle
Knob to the unlock position, moving head
until desired angle is achieved, then rotating
Head Angle Knob back to the lock position.
7. Install fully charged Battery Pack.
8. Put on safety goggles.
nOticE:
to prevent damage to tool or property,
avoid contact with fences, trees, shrubs and the like.
9. Rest Trimmer on Wheel Assembly.
10. Holding Trimmer with both hands, press
Trigger Safety Lock, then press Trigger.
11. Do not force the Trimmer. Use the
tip of the Line to do the cutting.
12. Release Trigger when done.
13. When finished, to prevent accidents:
• Remove Battery Pack.
• Wipe external surfaces of the tool
with clean cloth. Store in a dry, indoor
area out of reach of children.
