2. S
AFETY
F
IRST
BATCO - T
OP
D
RIVE
F
IELD
L
OADER
2.4. H
YDRAULIC
S
AFETY
1300 P, 1500 P S
ERIES
10
P1512121
2.4. HYDRAULIC SAFETY
• Always place all tractor hydraulic controls in neutral before disconnecting
from tractor or working on hydraulic system.
• Make sure that all components in the hydraulic system are kept in good con-
dition and are clean.
• Replace any worn, cut, abraded, flattened, or crimped hoses.
• Do not attempt any makeshift repairs to the hydraulic fittings or hoses by
using tape, clamps, or cements. The hydraulic system operates under
extremely high-pressure. Such repairs will fail suddenly and create a hazard-
ous and unsafe condition.
• Wear proper hand and eye protection when searching for a high-pressure
hydraulic leak. Use a piece of wood or cardboard as a backstop instead of
hands to isolate and identify a leak.
• If injured by a concentrated
high-pressure stream of
hydraulic fluid, seek medical
attention immediately. Seri-
ous infection or toxic reaction
can develop from hydraulic
fluid piercing the skin surface.
2.5. ELECTRIC MOTOR SAFETY
• To prevent serious injury or death, only qualified personnel should service
electrical components.
• Keep electrical components in good repair.
• Ground electric motor before using.
• Inspect drive belts before using. Replace if frayed or damaged.
2.6. STORAGE SAFETY
• Store the unit in an area away from human activity.
• Do not permit children to play on or around the stored equipment.
• Fully lower conveyor before storing.
2.7. TIRE SAFETY
• Failure to follow proper procedures when mounting a tire on a wheel or rim
can produce an explosion that may result in serious injury or death.
• Do not attempt to mount a tire unless you have the proper equipment and
experience to do the job.
• Have a qualified tire dealer or repair service perform required tire mainte-
nance.
