BlackDB1.1
Technical Data 1
Firstly, thank you for your purchase. Every element of this product has been optimized
to give you the best possible performance for your money. We think that Bass Face
represents the highest quality to price ratio available on the market today.
Please take the time to read these instructions carefully. You will need to follow them to
have a successful install and get the most from the product.
Do remember that incorrect installation or abuse is NOT covered under warranty – it is
YOUR responsibility to make sure that your installation and partnered product is suitable
and compatible.
Before you even get the amplifier out of the box (realistically, you will have done this
already and boy it looks sweet doesn’t it!) you will need to install a suitable wiring kit in
your vehicle. We recommend the use of a 4AWG wiring kit with appropriate termination for
maximum performance, especially if you will be running the amplifier at 1 ohm impedance.
If you are planning to run multiple amplifiers you will need to up the gauge of the wiring
accordingly. Do bear in mind that many manufacturers offer wiring kits that actually come
up smaller in true wire gauge than advertised.
To begin, disconnect the car battery, taking note of any required precautions suggested
by the vehicle manufacturer such as alarm or radio codes, or on board computer or AGM
battery requirements.
You need to find a suitable point on the firewall (bulkhead) to run the power wire through.
