Configuring the Camera
4-20
BASLER A102
k
DRAFT
4.2.4.15 White Balance
The white balance commands allow you to change the color balance in captured images by
individually adjusting the gain for different colors (see Section
). Four commands are
available: red gain, green gain 1, green gain 2, and blue gain.
Red Gain
Purpose:
To adjust the gain for the red pixels in the image.
Type:
This is a read or write command.
Read Command:
Cmd-ID
R/W-Flag
Data Length
Data
0x8D
1
1
-
Response:
Cmd-ID
R/W-Flag
Data Length
Data
0x8D
0
1
1 Byte
Write Command:
Cmd-ID
R/W-Flag
Data Length
Data
0x8D
0
1
1 Byte
Response:
None
Data Format:
Byte 1
The setting for red gain.
Data Range:
Red gain settings can range from 0 (0x00) to 63 (0x3F).
A setting of 0 (0x00) will reduce the gain on the red pixels by approximately
6 dB. A setting of 32 (0x20) will result in no change in the gain on the red
pixels. A setting of 63 (0x3F) will increase the gain on the red pixels by
approximately 6 dB.
Summary of Contents for A102K
