Basler Vision Technologies Sprint Series, User Manual

Page: 184 / 236

Configuring the Camera
174 Basler sprint Mono Cameras
Offset CSR
Note: The offset can be set by writing a floating point value to the Absolute Offset field or by writing
an integer value to the Raw Offset field. See Section 7.2.2.1 on page 164 for an explanation of the
difference between these two fields.
Register Base Address: 0x0F00
Field Name: Register Status Offset: 0x0000 Size: 1 Byte Type: Read only
Description: The integer value in this field indicates the status of this control and status register:
0x00 = The register is not available
0x01 = The register is available and all related settings are OK
0x80 = A value in the register is set out of range
Field Name: Absolute Offset Offset : 0x0001 Size: 4 Bytes Type : Read/Write
Description: Writing a floating point value to this field directly sets the offset in DN (digital numbers). For
example, if you set this value to +5.00, you would increase the digital values output from the
camera by 5.
The allowed range for the absolute offset can vary depending on how the camera is configured.
You should check the absolute min and absolute max fields of this register to determine the
allowed range with the current configuration. The increment is 0.01.
The value in this field is a standard IEEE-754 single precision (32 bit) floating point number.
See Section 6.1 on page 115 for more information about offset.
Field Name: Absolute Min Offset : 0x0005 Size: 4 Bytes Type : Read only
Description: Minimum allowed floating point value for the absolute offset setting.
The value in this field is a standard IEEE-754 single precision (32 bit) floating point number.
Field Name: Absolute Max Offset : 0x0009 Size: 4 Bytes Type : Read only
Description: Maximum allowed floating point value for the absolute offset setting.
The value in this field is a standard IEEE-754 single precision (32 bit) floating point number.