- 37 -
Fig. 4
At the same time, loosen the carriage
adjustment knob. If you cannot fully loosen it,
pull the carriage once more towards the
carriage adjustment knob until there is an
audible click of protection device.
Fully loosen the guide adjustment knob
and remove the guide from the device by
pulling it up.
Fig. 5
15
Sharpener
as the upper knife cover;
There is a magnetic joint on the sharpening
machine (
a
): the device works properly only
with the correctly set sharpener.
If you remove a sharpener during the
operation, the device will stop. After correctly
installing the sharpener again, the device will
not start automatically, but must be switched
on again using the white
START
button
–
ON/OFF switch.
5. Installation and operation
5.1 Installation
Positioning
Unpack the device and remove and utilize the packaging material according to the
environmental protection regulations.
CAUTION!
Never remove the rating plate and any warning signs from the device.
Place the device on top of an even and safe surface which supports the weight of
the device and make sure it cannot tilt at any time.
Place the device at height of approx. 80 cm.
Not
at any time
should you place the device on an inflammable surface.
Put the device in a room with maximum 70% moisture level, where the temperature
ranges from +5 °C to +32 °C.
Leave space around the device and keep away from other devices and equipment
in order to ensure the correct operations of the slicer.
15
a