Bartscher 110665, Instructions For Use And Maintenance Manual, Page: 8 / 19

EN
page 26
2.
CONTROL PANEL AND RELATIVE SYMBOLS
A) Cycle light indicator
B) Full tank indicator
C) Button, not available
D) Heating tank indicator
E) Heating boiler indicator
F) START key to start up cycle / Programming key
G) Switching ON / OFF / Programming key
H) Info (temperature / software review / key factory)
I) Regeneration key (optional) / Decrease
L) Drain Pump key (optional) / Increase
M) Display
3.
OPERATION
3.1 Machine start-up
3.1.1 Start-up
• Check if the pump suction fi lter is properly inserted in its seat in the wash-tank
bottom (see pict. 1).
• This fi lter must be cleaned every 20 wash-cycles or whenever necessary.
•
DO NOT use the appliance without the fi lter.
• Insert the overfl ow pipe in its seat inside the pump suction fi lter (see pict. 1).
• Put the surface fi lters in place (see pict. 1).
• Shut the dishwasher door.
• Turn the water valve “open”.
• Turn the main power switch ON.
• The display
M will show, for a few seconds, the installed software version code.
• The machine is on STAND-BY . In the M display, the message STAND-BY will
appear.
• Turn the button G .The LED positioned below the G control, will light (green color) at the machine’s start (when the machine
is on STAND-BY mode, the LED will turn red).
The display M will read FILLING WATER .
Should the machines be equipped with the WRAS certifi ed Break Tank, the tank fi lling phase is extended.
The display will read
HEATING , till wash-tank and boiler will reach the set temperatures.
stand-by
filling water heating
Pict. 1