Installation and operation
104304
15 / 30
EN
Power supply connection
• Verify if technical data of the appliance (see rating plate) correspond with the
local electric power grid specification.
• Connect the appliance to a single, properly grounded mains socket with
protective contact. Do not connect the appliance to a multi-socket.
• The power cord should be laid in a way preventing anyone from threading on it
or tripping against it.
• The maximum allowable tolerance for voltage difference is ±10% of rated value.
• The electric circuit between the appliance and the power supply connection
should be equipped with a suitable multi-polar disconnecting device (Fig. 7),
which is capable of providing distance of contact opening rendering full
separation possible in the conditions of overvoltage category III.
• If in winter the appliance is brought from the outside to a room, leave it for a few
hours to heat up and reach the room temperature before switching it on.
• Before connecting the appliance to the power supply, wait 1 hour for the coolant
to stabilize.
• After a power failure or when the plug is removed from the socket, reconnect the
appliance to the power supply after 5 minutes at the earliest.
•
The el ectric soc ket s hould be easil y accessibl e s o it is pos sibl e t o quic kl y disconnect t he power c ord when nec ess ar y.
The el ectric soc ket s hould be easil y accessibl e s o it is pos sibl e t o quic kl y disconnect t he power c ord when nec ess ar y.
The el ectric soc ket s hould be easil y accessibl e s o it is pos sibl e t o quic kl y disconnect t he power c ord when nec ess ar y.
5.2
Operation
Preparation of Appliance
1. Remove all accessories from the storage container (water supply tube, water
drain tube, ice shovel, documentation).
2. Before use, clean the appliance observing instructions in section 6
'Cleaning'
.
3. Dry the appliance thoroughly.
