- 29 -
5.
Installation and operation
5.1. Installation
5.1.1. Location
Remove the device from the packaging and discard all the packing materials.
Never remove the rating plate or any warning signs from the device.
The installation place must be easily accessible and sufficiently spacious to allow
easy operation of the device and good air circulation.
Allow 10 cm space at the sides and at the rear away from the walls and other
objects.
In case of the smaller space place the protective elements, e. g. heat resistant
film.
Locate the device in a well-ventilated room.
Place the device on top of an even, stable, dry, and water and heat resistant
surface.
Never place the device directly underneath a hanging cupboard as hot air moves
upwards.
Never use the device at the edge of a table as the device may fall over and down.
Locate the device so that the plug is easily accessible and can be quickly
disconnected from the power supply, if necessary.
Remove the protective film from the device before use. Remove the film slowly in
order not to leave the glue residues. Any glue residues may be removed with the
use of proper solvent.
Insert the crumb tray into the provided slot underneath the device.
5.1.2. Connection
DANGER!
Risk of fatal electric shock!
Incorrect electric installations or too high mains voltage may cause electric shock.
Connect the device to a single grounded socket with 16A protection
1. Verify if the technical specification of the device (see the rating plate) correspond to
the local electricity grid.
2. Position the device.
3. Fully unwind the power supply cord.
4. Plug in to the grounded socket.
The device is ready for use.
Summary of Contents for 100282
Page 1: ...TS20Sli 100282 Original Bedienungsanleitung V1 0917 ...
Page 2: ......