BAR H
Elektronik GmbH
®
3/6
9021-0021-A
09.05.2019
A
Page:
Document:
Date:
Revision:
Parameter Programmer
PG-65
Art. No. 0017-0065
MANUAL
© 2017 BARTH Elektronik GmbH | Im Depot 1-3 | D-49838 Lengerich | www.barth-elektronik.de
® BARTH is a registered trademark. All rights reserved.
9021-0021-A
1.4
Delivery content
• BARTH
®
Parameter Programmer PG-65
• 4-pole Connector for Supply and CAN
• Charging Cable USB2.0A -> USB micro-B
2
Operation
2.1
General
Please download the related Product
Documentation and Software:
https://barth-elektronik.com/en/
getstarted.html
The PG-65 Parameter Programmer is carried out as a
handheld device integrated in a rugged aluminium diecast
housing with a color touch TFT and frontside connectors.
The connector layout of the PG-65 is shown in the picture
below.
The micro-USB port (left) is reserved for charging or powe-
ring the PG-65 via USB or USB-specified 5VDC power
adaptors and power banks.
The IrDA window (center) is used for Mini-PLC communi-
cation and must not be covered as a visible connection is
mandatory for proper communication.
The 4-pole power supply/CAN connector (right) integrates
both supply (7 to 32VDC) and CAN (CANH, CANL) terminals.
The following picture shows the main menu layout which
appears after launching the PG-65.
Four buttons are availabe for active operations.
The following table explains the symbols of the main screen:
PG-65 works in battery mode.
Battery capacity is at high level.
PG-65 works in battery mode.
Battery capacity is at medium level.
PG-65 works in battery mode.
Battery capacity is at low level.
PG-65 is connected to USB port or to
an adaptor or power bank.
Battery is in charge mode.
PG-65 is connected to USB port or to
an adaptor or power bank.
Battery has been fully charged.
Switch OFF the PG-65.
Read parameter(s) from Mini-PLC.
Store parameter(s) in Mini-PLC.
Edit parameter(s).