Bartec Tech200BT, User Manual

Page: 6 / 44

Tech200BT User Guide rev3.0 April 2014
1.6 Charging your tool
The Tech200 is shipped from the factory with a fully charged battery, however
it is recommended that you charge your tool a minimum of four [4] hours
before using.
Use of un-approved power supplies may damage your tool and will
void the tool warranty.
The Tech 200 comes with the rechargeable battery already installed.
Battery replacement must be done at the factory.
For optimum performance, always keep your Tech 200 sufficiently charged. It
is recommended that you charge the tool 2 + hours before first use.
Alternate Charging Methods:
A. USB Cable to PC
You can also charge the Tech 200 using the supplied USB cable attached to your
computer.
6