Safety precautions
3
Measuring System MAK TIGER 3003 Service manual, SA 131128, 10.03.2020
2.2
Installation instructions
Install the units as necessary in order to meet the ambient temperature
specifications. Use enclosures, heating or cooling systems to protect them
if necessary.
The installation location should be as vibration-free as possible. Use sturdy
retaining fixtures to protect all the components from vibrations.
The printer must be installed in a permanently clean and dry location.
The power supply to the system must be stopped during welding
work or assisted starting on the vehicle.
Take measures to keep the units clean during installation, especially the
printer (e.g. protect from metal cuttings, etc.).
Do not blank off unassigned cable glands.
Remove the transportation lock from the printer before putting it into oper-
ation.
All built-in solenoid valves must be shielded from interference (suppressor
diode).
2.3
Wiring instructions
The wiring must be undertaken by trained professionals.
The installation must be carried out in accordance with the relevant na-
tional regulations.
The unit must be wired with exclusive reference to, and in strict compliance
with, the servicing instructions.
The connection cables must be fitted in such a way as to eliminate any
sagging.
An allowance of approx. 15 - 20 cm is advisable for attachment with clips
or cable ties.
Extra care is needed when fitting the cables near the radiator, in the engine
compartment, in parts of the truck frame and in the delivery cabin.
Under no circumstances should there be any vulnerable points where the
cables are kinked or susceptible to abrasion.
Fit the cable ends with ferrules.
Tighten the screws on non-assigned terminals.
2.4
Servicing and repair instructions
Servicing and repairs must be carried out by trained professionals only.
Switch the units off before servicing and repair work, and take measures
to prevent them from being switched back on while servicing and repair
work is in progress.
