Barry-Wehmiller BW Integrated Systems Streamfeeder V-1400IJ, Manual

Page: 12 / 57

5 V-1400IJ M
anual
When performing initial installation, always make sure you turn Off the main power switch and disconnect all equipment from the electrical
power source. Failure to do so can expose you to a potential startup and moving parts which can cause serious injury.
Do not attempt feeder installation while the feeder and machine of application are running. Failure to do so can expose you to moving parts which
can cause serious injury. Do not wear loose clothing when operating the feeder.
Avoid turning on the feeder or making initial adjustments until all parts are secured. Failure to do so can cause damage to equipment.
This section provides information on installing the V-1400IJ onto a
vacuum or non-vacuum transport base.
Information for a particular application typically includes procedures
for basic parts removal, feeder mounting and alignment, and cable
connections for power and control interface.
Information that relates
to specific adjustments you must make to feeder prior to startup and
operation is found in Section 3, “Preparing for Operation.”
2
Installing the Machine
Vacuum Base
Installation for
Shuttle Feed Bases
Installation of the V-1400IJ onto various types of vacuum and non-
vacuum bases is a relatively simple procedure. Several minor modifi -
cations to the vacuum base are required prior to mounting, wiring, and
aligning the feeder.
To install the feeder onto a shuttle feeder vacuum base, perform the
following steps:
1: Repositioning front side guides
2: Removing back jogging plate/back hopper guide
3: Raising hopping rollers
4: Disabling the shuttle
5: Initial positioning of feeder
6: Providing AC power to feeder
7: Connecting run enable input
8: Checking product discharge from feeder
Included with your V-1400IJ 230V feeder is an Allen Wrench Set (P/N 23511CC1). These tools are designated for Service Personnel only.