Barry-Wehmiller BW Integrated Systems Streamfeeder V-1400IJ, Manual

Page: 11 / 57

4
V-1400IJ M
anual
Control Features Descriptions
On Delay Adjustment
Feature Description
Variable speed control This dial switch (labeled Speed ) allows the feeder speed to be
synchronized with a vacuum or non-vacuum base. Turning counter-
clockwise decreases speed; clockwise increases speed. Note: Feeder
motor stops if turned completely counter-clockwise.
Run Enable switch This slide switch allows you to use the feeder “stand- alone” or with the
run enable input interface .
Speed switch This slide switch allows you to
AC power cordset connector Cordset plugs into this connector to provide feeder with power from a
grounded and fused outlet.
Power On/Off Toggles AC power On or Off.
Fuse holder
Contains two replaceable 5-Amp, 5x20 mm time delay fuses.
IMPORTANT: Always make sure power module is replaced exactly as
removed so that “115” is always visible on 115V models and "230" is
always visible on 230V models. Failure to follow this caution can result in
damaged electrical parts.
Run Status connector
An interface available for host systems. Provides feedback to host system
whether the feeder is running or not.
Run Enable connector This 4-pin connector is used to carry start/stop signals from a vacuum or
non-vacuum base to the feeder.
On delay adjust Located on circuit board on inside of panel. See photo below.
Used to delay (or synchronize) feeder startup with base startup. Range is
adjustable from 0 to 12 seconds (factory set at 0 seconds).