Barry-Wehmiller Accraply 204RH, Operation And Maintenance Manual

Page: 22 / 97

14 SECTION 1: SYSTEM OPERATION
1.3 General Information
1.3.1 Shipping and Handling
1. Position the Labeler where it is going to be used. Make sure it is properly balanced and secure.
2. Remove all banding and wrapping materials (including plastic tie wraps, cloth bands, padding, etc.) that were
installed for shipping.
Note: The Labeler may be heavier on one side due to installed equipment. Be careful when lifting the machine that it
does not tilt to one side and fall over.
1.3.2 Service Requirements
Capacity/Characteristics
Electrical 120 VAC
Air 80 PSI
See Section 3 for more detailed requirements.
1.3.3 Technical Data
Products Carton: 7-3/4” L x 5-3/8” W x 1-1/4” H
Labels
Seal: 1-3/4” L x 3/4” W
Line Speeds
20 Products per minute
System Description • Accraply 204 Label Applicator
• Ultrasonic Label Sensor for Clear or Opaque Labels
• Dual Label Application Set-Up
• Automatic Product Speed Following Encoder
• Product Sensor Assembly
• Mounting Assembly
• Belt Conveyor
• Dual Product Gating/Spacing Wheels
• Carton Rotation Device
• Custom Label Wipe-Down
• Cognex Checker System
• Carton Eject System
• Electrical Panel
• AB PLC
• Alarm Package
• Alarm Light Mounting Post
• Safety Guarding
• Lockable Air Shut-Off
• Air Dump with Soft Start
• Carton Squaring Device
GENERAL INFORMATION