Assembly of VEX-8 inside NEMA enclosure for NY
1. Remove the front face of the VEX fixture using a screwdriver. (Fig. 1 and 2)
2. Remove the LED indicator and test button from the side of the enclosure, making note of the location on the PCBA
where they are plugged in and discard. (Fig 3)
3. Open the clear cover of the NEMA enclosure by flipping the plastic latches up. (Fig. 4)
VEX-8 NEMA
INSTALLATION INSTRUCTIONS
800.533.3948 • www.barronltg.com
1
10070205 REV 2 - 09/18
IMPORTANT SAFEGUARDS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
When using electrical equipment, basic safety precautions should always be followed including the following:
•
DISCONNECT AC POWER SUPPLY BEFORE SERVICING.
• Installation and servicing of this equipment should be performed by qualified service personnel only.
• Ensure that the electrical wiring conforms to the National Electrical Code NEC® and local regulations if applicable.
• Do not mount near gas or electrical heaters.
• Equipment should be mounted in locations and at heights where it will not be readily subjected to tampering by
unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Any modification or use of non-original components will void the warranty and product liability.
• Do not use this equipment for other than intended use.
SAVE THESE INSTRUCTIONS!
1
2
3
4
