Barreto 825TKL, Operator'S Manual

Page: 23 / 28

825TKL OPERATOR’S MANUAL 2/10/20 Page 23 of 28
ROAD TRANSPORT OF THE 825TKL
The 825TKL must be transported on a trailer with a minimum weight rating of 3500lbs
Refer to the following checklist before towing:
•
Towing vehicle should have the correct size ball. Be sure it is in good repair and securely
fastened to the vehicle.
•
Securely fasten the hitch to the ball by tightening the hitch nut.
•
Thread the safety chain through the loop in the hitch nut handle to prevent it from vibrating loose
while towing.
•
Attach the safety chain to the towing vehicle in such a way that it cannot come off accidentally.
•
Check the hitch-to-ball connection after driving a few blocks and re-tighten if necessary.
Always exercise extreme caution and allow extra clearance while towing a trailer. DRIVE SAFELY!
LOADING PROCEDURE:
1. Trailer and vehicle should be located on level ground before loading the 825TKL
2. If the trailer ramp angle is greater than 10°, the 825TKL should be loaded in reverse to allow
the bucket or attachment to prevent the unit from tipping forward.
3. Drive the machine onto the trailer and position the machine to provide adequate tongue
weight on the towing vehicle (tongue weight should be 10-20% of total towing weight).
4. Raise lift arms to allow access to the tie down point at the front of the 825TKL body, between
the tracks.
5. Loop a chain through the front tie down point and secure chain with a quick-link or chain
binder.
6. Loop a second chain through both rear tie down points and secure with a chain binder.
7. Lower the lift arms down onto the chain securing the front of the unit and apply a small
amount of downward pressure on the chain.
8. Shut down machine following the shut down procedure.