Baroness TDA1200, Service Manual

Page: 44 / 89

Remove the rear roller by sliding it to the
right.
1
oxwlid-008
Removal of rear roller Assy_008
1 Rear roller
Installation of rear roller Assy
Caution
Refer to "Tightening torques" (Page 3-4) .
Note that the Baroness product warranty may
not apply to any defects caused by incorrect
or overtorque tightening, etc.
For installation, reverse the removing
procedure.
Front roller bracket
Removal of front roller bracket
Install the sling to the rear frame and lift it
with a hoist, etc. until the rear roller lifts off
the ground.
1
2
3
oxwlid-001
Removal of front roller bracket_001
1 Rear frame
2 Sling
3 Rear roller
9.
1.
Remove snap pin A and the flat-head pin
securing the rear roller Assy.
Follow the same steps to remove those on
the other side.
1
2
kqszfp-001
Removal of front roller bracket_002
1 Rear roller Assy
2 Snap pin A and flat-head pin
Remove the bolt, washer, and U nut and
then remove the bracket mounting board.
Follow the same steps to remove those on
the other side.
2
1
oxwlid-007
Removal of front roller bracket_003
1 Bolt, washer, and U nut
2 Bracket mounting board
Place the jack stands under the rear frame
pipe.
1
2
kqszfp-002
Removal of front roller bracket_004
2.
3.
4.
TDA1200
・
TDA1600
Operating Machine and Mower Units
Page 4-22
Removal and installation of each section