Baroness SP05A, Owner'S Operating Manual

Page: 70 / 76

Change of Engine Oil Filter
Caution
Be careful with hot oil, which could cause
burns if it contacts your skin.
Important
When replacing the engine oil filter, be sure to
drain the engine oil into a container and
discard it in accordance with local laws and
regulations.
Important
Be sure to use engine oil that is classified as
API Service Grade SF or higher, with an SAE
Viscosity that is appropriate for the operating
environment (ambient temperature).
Important
Securely tighten the oil level gauge and oil
filler cap.
With the filter wrench, remove the old filter
cartridge.
1
2
3
5
4
zuw5ff-001
Change of Engine Oil Filter_001
1 Engine
2 Filter cartridge
3 Oil filler cap
4 Oil level gauge
5 Drain plug
Lightly coat the packing of the new filter
cartridge with engine oil.
Hand-tighten the filter cartridge until the
packing contacts the sealing surface, and
then hand-tighten additional 1/2 to 3/4 turn
from that point (without using a filter wrench).
1.
2.
3.
Supply engine oil until it reaches the
specified level.
"Supply of Engine Oil" (Page 4-8)
Start the engine, and then stop it after 10 to
20 minutes.
Make sure that there is no oil leakage at the
sealing surface of the filter cartridge.
Check the engine oil level.
If it is low, supply engine oil until it reaches
the specified level.
Change of Fuel Filter
Important
While installing the fuel filter, prevent
contamination with dirt or dust.
The fuel contaminated with dirt or dust will
cause engine failure.
Since the fuel filter is a cartridge, it cannot be
disassembled or cleaned.
If dust or dirt accumulates in the fuel filter, the
fuel flow will become insufficient.
Replace the fuel filter at the appropriate times.
Remove the old fuel filter.
Install a new fuel filter with the arrow marked
on it pointing toward the engine.
1
A B
rvnnv5-007
Change of Fuel Filter_001
1 Fuel filter
A Engine
B Fuel cock
4.
5.
6.
7.
1.
2.
SP05A
Maintenance
Page 5-18
Maintenance Work