Baroness SP05A, Owner'S Operating Manual

Page: 67 / 76

1 Push-pull cable
2 Lock nuts
3 Connection point on pedal
Insert the push-pull cable, and then install
the washer and cotter pin.
3
2
1
hsn2jo-003
Adjusting The Neutral Position of The Piston Pump_005
1 Push-pull cable
2 Cotter pin
3 Washer
Change of Hydraulic Oil
Caution
Be careful with hot oil, which could cause
burns if it contacts your skin.
Important
If the oil emulsifies or if it becomes even
slightly less transparent, change the oil
immediately.
Important
When you change the hydraulic oil, be sure to
drain it into a bowl and discard it in
accordance with local laws and regulations.
Important
Use Shell Tellus S2V32 (or equivalent) as
hydraulic oil.
Follow the steps below to remove the old oil.
Start and run the engine to warm up the
oil.
On a level surface, lower the rake, and
then stop the engine.
9.
1.
[1]
[2]
Remove the drain plug of the hydraulic
tank, and then drain the old oil into a
container.
Wind new sealing tape on the drain plug,
and then attach it to the hydraulic tank.
1
2
pfdche-002
Change of Hydraulic Oil_001
1 Hydraulic tank
2 Drain plug
Open the tank cap, and then pour new oil
from the fill port until the oil level reaches the
middle of the oil gauge on the hydraulic tank.
The hydraulic tank capacity is approximately
15.0 dm
3
(15.0 L).
1
dmhzyz-003
Change of Hydraulic Oil_002
1 Tank cap
Tighten the tank cap securely.
Start the engine, raise and lower the rake,
and repeatedly move forward and backward
several times with the rake raised.
Raise the rake and maintain that position on
a level surface, and then check to see if the
oil level is at the middle of the oil gauge. If
necessary, supply oil.
Check underneath the machine for oil
leakage.
[3]
[4]
2.
3.
4.
5.
6.
Maintenance
SP05A
Maintenance
Page 5-15
Maintenance Work