Baroness SP05A, Owner'S Operating Manual

Page: 66 / 76

Adjusting The Neutral Position of The
Piston Pump
If the machine moves forward or backward
while the traveling pedals are released, they
are not set to the neutral position.
Follow the steps below to make adjustments.
Stop the engine.
Remove the cotter pin and washer at the
pedal end, and then remove the end of the
push-pull cable.
3
2
1
hsn2jo-003
Adjusting The Neutral Position of The Piston Pump_001
1 Push-pull cable
2 Cotter pin
3 Washer
Place the jacks securely beneath the jack-up
points, and then lift the machine off the
ground.
Use stable jack stands, and raise the
machine until the tires lift off the ground.
"Jack-Up Points" (Page 5-4)
Start the engine, and rev it up to the
maximum rpm.
Set the 2WD/3WD selector lever to the
"2WD" position.
Warning
When adjusting the neutral position, exercise
care so that the hand does not get entangled
in the rotating parts.
1.
2.
3.
4.
5.
Slowly turn the camshaft until the rear wheel
stops, and then use the nut to lock the
camshaft at the stopped position.
1
3
2
hsn2jo-002
Adjusting The Neutral Position of The Piston Pump_002
1 Piston pump
2 Nut
3 Camshaft
Loosen the lock nuts.
1
2
hsn2jo-004
Adjusting The Neutral Position of The Piston Pump_003
1 Push-pull cable
2 Lock nuts
Adjust the end of the push-pull cable at the
pedal end so that it attaches to the
connection point on the pedal, and then
tighten the lock nuts.
3
1
2
hsn2jo-005
Adjusting The Neutral Position of The Piston Pump_004
6.
7.
8.
SP05A
Maintenance
Page 5-14
Maintenance Work