Baroness SP05A, Owner'S Operating Manual

Page: 35 / 76

Adjustment of Speed Adjustment Plate
Warning
Since it is dangerous, do not adjust the speed
adjustment plate while traveling.
The height of the speed adjustment plate can
be adjusted with the bolts.
Use the speed adjustment plate to operate the
machine at a constant speed.
Loosen the bolts.
Determine the operating speed, adjust the
height of the speed adjustment plate, and
then tighten the bolts.
3
4
1
A
B
2
agnhvb-002
Adjustment of Speed Adjustment Plate_001
1 Speed adjustment plate
2 Bolt
3 Forward pedal
4 Reverse pedal
A Slow
B Fast
Adjustment of Rake
Caution
Before adjusting the rake, be sure to stop the
engine.
The rake can be adjusted with the nut.
On a level surface, lower the rake, and
then drive the machine forward about
approximately 200 mm (7.87 in).
Place a wooden board with a thickness of
about 15 mm (0.59 in) under the warp
board.
1.
2.
1.
[1]
[2]
Adjust the fork prong bar to a position
where the rake load is applied to the
wooden board and the tip of the fork prong
bar lightly touches the ground, and then
lock it in place with the nut.
1
2
3
4
5
15 mm (0.59 in)
mafeci-001
Adjustment of Rake_001
1 Warp board
2 Nut
3 Fork prong bar
4 Flat concrete surface
5 Wooden board, etc.
When adjusting the links of the cross-link
chains, adjust the rake stopper.
As a standard, 7 links of the chain are used.
Loosen the nut.
Raise the rake.
Adjust the rake stopper so that it lightly
touches the rake, and then tighten the nut.
Raise and lower the rake to check that it
lightly touches the rake stopper.
4
3
2
1
mafeci-006
Adjustment of Rake_002
1 Cross-link chains
2 Rake stopper
3 Nut
4 Rake
[3]
2.
[1]
[2]
[3]
[4]
Handling Instructions
SP05A
Handling Instructions
Page 4-15
Adjustment before Work