Adjustment of Cutting Height
Cutting Height Adjustment
Caution
Do not perform the operation with any other
persons.
Adjust the cutting height to fit your cutting
work.
The rear roller can be adjusted to one of four
settings.
A
B
C
D
9pu8ye-005
Cutting Height Adjustment_001
A
10 - 17 mm (0.39 - 0.67 in)
B
10 - 33 mm (0.39 - 1.30 in)
C
21 - 39 mm (0.83 - 1.54 in)
D
28 - 46 mm (1.10 - 1.81 in)
Note:
With the same cutting height for settings A
and B, the clippings volume with B will be
larger since the offset distance is longer.
The same goes for settings B and C and
settings C and D.
Attach the rear roller in a position that suits
your work requirements within the cutting
height range.
1.
Set the slide caliper to the required cutting
height, adjust the neck position of the small
screw for cutting height setup of the cutting
height gauge and securely lock with a fly
nut.
1
2
9pu8ye-007
Cutting Height Adjustment_002
1
Cutting height gauge
2
Small screw for cutting height setup
Loosen the nut which fixes the roller
bracket of the front roller.
Apply the cutting height gauge to the front
and rear rollers at each edge of left and
right of the mower unit.
Adjust the front roller up and down by the
roller adjuster to determine the position of
the front roller, in order not to have a gap
with the neck position of the small screw for
cutting height setup of the cutting height
gauge, at the edge of the bed knife.
3
A
2
1
3kws2a-007
Cutting Height Adjustment_003
1
Bed knife (bottom blade)
2
Small screw for cutting height setup
3
Cutting height gauge
A
Cutting height
2.
3.
4.
5.
LS62
・
LS66
Handling Instructions
Page 4-8
Adjustment before Work
