Baroness LM66GC, Owner'S Operating Manual, Page: 55 / 85

Maintenance Item
Before Work
After Work
Every 10 hrs. Every 20 hrs. Every 25 hrs. Every 50 hrs.
Every 100 hrs. Every 300 hrs. Every 500 hrs.
Every year
Every 2 years
When Required
Remarks
Cutting section
Adjust groomer
○
Refer to "Adjustment of
Groomer"
Check damaged parts
○
Check tightening bolts and nuts
○
Clean Cutting section ○
Grease
○ ○
Refer to "Greasing
Points"
Replace bearings inside
gearcase
△
Replace front roller bearings
△
Replace oil seals inside
gearcase
△
Replace front roller oil seals △
Replace grease inside gearcase △
Clean and Grease Bedknife
Eccentric Bushes
○
Adjust cutter adjustment spring
○
Refer to "Adjustment of
Cutter Adjustment
Spring"
Backlap blades
○
Refer to "Back Lapping
of Reel Cutter (Cutting
Cylinder)"
Regrind blades (Reel cutter and
Bed knife)
○
Regrind/Replace blades
as and when required
*1: Consult your local Baroness Dealer for this service.
*2: Refer to the Engine's Owner's Manual.
The values for consumables are not guaranteed.
Specified Values
Fuel tank capacity
2.0 dm
3
(2.0 L)
Gasoline
Engine oil capacity
0.56 dm
3
(0.56 L)
SAE30 (API Service Grade SE or
higher)
Engine plug - NGK BPR4ES
Tire pneumatic pressure
120 kPa (1.2 kgf/cm
2
)
4.10/3.50 - 6
Cutter adjustment spring 50.0 mm (1.97 in) Length of coil spring
Reel cutter shaft bearing preload
spring
11.5 mm (0.453 in) Total length of spring
Reel cutter rotation torque 0.8 - 1.0 N
・
m (8 - 10 kgf
・
cm)
Engine clutch 0.5 - 1.0 mm (0.020 - 0.039 in)
Gap between engine clutch and
clutch facing
Operation distance of clutch plate 1.0 - 2.0 mm (0.039 - 0.079 in)
Engine clutch spring 61.0 mm (2.40 in) Total length of spring
･
･
･
Maintenance
LM56GC
・
LM66GC / LM66TC
Maintenance
Page 5-5
Maintenance Schedule