Baroness LM56GC, Owner'S Operating Manual

Page: 41 / 88

Adjustment of Groomer
Note:
Depending on the specifications, this function
may not be available.
Important
If the front groomer is being used, adjust it
according to the conditions of the greens.
Important
Set the grooming height more than 0.0 mm
(0.00 in) from the ground.
Allowing the front groomer to go into the
ground will damage the groomer shaft.
Important
If the front groomer goes in too deep, the
engine and drive components may become
overloaded, which will cause malfunction and
damage.
Important
When using the grooming brush, adjust it to
the same height as the cutting height.
If the grooming brush is too low, it may quickly
become damaged.
Set the slide caliper to the required groomer
height, adjust the tip of the groomer setting
screw on the cutting height gauge, and then
securely lock it with a wing nut.
1
4
3
2
A
2qrq2r-002
Adjustment of Groomer_001
1 Dethatching blade
2 Small screw for groomer setup
3 Cutting height gauge
4 Front roller
A Groomer height
1.
Loosen the nuts securing the left and right
groomer adjustment screws.
Loosen left and right special nut A.
6 1
2
5
4
3
2qrq2r-003
Adjustment of Groomer_002
1 Groomer adjustment screw
2 Nut
3 Special nut A
4 Special nut B
5 Spring
6 Front groomer
Position the cutting height gauge against the
front roller and drum at the edge on the left
and right sides of the mower unit.
Important
Adjust so that the small screw for groomer
setup contacts the dethatching blades.
Adjust special nut B up or down so that the
left and right sides are parallel.
5
7
4
3 6 1
8
9
2
B
A
2qrq2r-008
Adjustment of Groomer_003
2.
3.
4.
5.
Handling Instructions
LM56GC
・
LM66GC / LM66TC
Handling Instructions
Page 4-17
Adjustment before Work