Baroness LM551, Service Manual, Page: 32 / 213

Jacking Up The Machine
About Jacking Up The Machine
Warning
When replacing a tire or beginning any other
maintenance or repairs, be sure to chock the
wheels to prevent the machine from moving.
Before jacking up the machine, park it on a
hard, flat surface such as a concrete floor and
remove any obstacles that could prevent you
from performing the work safely.
When necessary, use an appropriate chain
block, hoist, or jack.
Support the machine securely with jack stands
or appropriate blocks.
Failure to do so may cause the machine to
move or fall, resulting in injury or death.
Use the jack-up points identified in this manual
when jacking up the machine.
Only place a jack under the jack-up points
specified.
Placing a jack at any other point could result in
damage to the frame or other parts.
Jack-Up Points
2
1
4 3
rwyt62-103
Jack-Up Points_001
Jack-up points
1 Front right frame
2 Front left frame
3 Right pivot
4 Left pivot
Front right frame
rwyt62-104
Jack-Up Points_002
Front left frame
rwyt62-105
Jack-Up Points_003
Right pivot
rwyt62-106
Jack-Up Points_004
When jacking up the machine at the right
pivot, place a block of wood between the
right pivot and the frame.
Note:
Use a block of wood with a height of
approximately 130 mm (5.12 in).
1.
2.
3.
LM551
Maintenance Standards and Maintenance
Page 3-18
Jacking Up The Machine