Baroness LM551, Owner'S Operating Manual, Page: 82 / 102

Removing/Installing Tires
Front Tires
Follow the steps below to remove the front
tires:
Loosen the bolts.
1
lm2ieh-002
Front Tires_001
1 Heat-treated bolt
Securely place the jack beneath the jack-up
point of the front left/right frame area, and
then raise it until the tire lifts off the ground.
"Jack-up Points" (Page 5-9)
Remove the bolts.
Remove the tire from the wheel mounting
seat.
Caution
Refer to the Tightening Torque table.
Note that the Baroness product warranty may
not apply to defects caused by incorrect or
overtorque tightening etc.
Important
Tighten the bolts in the tightening order
(diagonally).
For installing the front tires, reverse the
removing procedure.
Rear Tire
Follow the steps below to remove the rear
tire.
Loosen the bolts.
1.
2.
3.
4.
1.
1
upekw4-002
Rear Tire_001
1 Bolt, heat-treated
Securely place the jack beneath the jack-up
point of the pivot, and then raise it until the
tires lift off the ground.
"Jack-up Points" (Page 5-9)
Remove the bolts.
Remove the tire from the wheel mounting
base.
Caution
Refer to the Tightening Torque table.
Note that the Baroness product warranty may
not apply to defects caused by incorrect or
overtorque tightening, etc.
Important
Tighten the bolts in the tightening order
(diagonally).
For installing the rear tire, reverse the
removing procedure.
Adjustment of Belt Tension
Warning
Be sure to stop the engine before adjusting
the belts.
Important
Make sure that the belt has the specified
amount of tension.
Before making sure of its specified tension,
rotate the belt several times.
If the belt becomes slack due to frequent use, it
may jump or slip.
2.
3.
4.
LM551
Maintenance
Page 5-18
Maintenance Work