Baroness LM551, Owner'S Operating Manual, Page: 54 / 102

Note:
When the mower units are raised, the reel
cutters (cutting cylinders) do not rotate, even if
the switch is set to the "Rotation" position.
1
A
B
mh4pyw-013
Reel Rotation Switch_001
1 Reel rotation switch
A Rotation
B Stop
Reel Forward/Reverse Switch
Important
Do not switch between
“
Forward
”
and
“
Reverse
”
while the reel cutter (cutting
cylinder) is rotating.
Otherwise, the hydraulic system may
malfunction.
Important
If the reel rotation switch is not set to the
"Rotation" position, the reel cutter (cutting
cylinder) will not rotate.
The reel forward/reverse switch is located
inside the underseat cover and switches the
rotation direction of the reel cutters (cutting
cylinders).
When the reel forward/reverse switch is set to
the "Forward" position, the reel cutters (cutting
cylinders) of all mower units will rotate for
cutting work. When the reel forward/reverse
switch is set to the "Reverse" position, the reel
cutters (cutting cylinders) will rotate in reverse
(back lapping rotation).
ON
OFF
LAPPING
A
B
1
uy5vc2-001
Reel Forward/Reverse Switch_001
1 Reel forward/reverse switch
A Forward
B Reverse
Reel Rotation/Stop Switching Lever
Caution
Before operating the reel rotation/stop
switching lever, be sure to set the reel rotation
switch to the "Stop" position.
The reel rotation/stop switching lever is located
on the reel motor attached to each mower unit.
It is used during cutting and back lapping.
Shift the lever(s) to the "Rotation" position only
for the mower unit(s) to be used for cutting or
back lapping. Leave the lever(s) for other
mower units in the "Stop" position.
A
B
1
zzpqiy-003
Reel Rotation/Stop Switching Lever_001
1 Reel rotation/stop switching lever
A Rotation
B Stop
LM551
Handling Instructions
Page 4-30
Operation of Each Section