Baroness LM331, Service Manual, Page: 123 / 165

Inspection and repair of each section
Brake
A worn brake shoe will increase the amount of
brake pedal depression, and may cause the
pedal to touch the floor or result in uneven
braking. Inspect the brake accordingly.
Adjust the brake shoe clearance to be even on
both sides. A brake shoe is gradually worn
down like an eraser as the brake is applied.
Check the remaining shoe amount upon
inspection and replace as needed.
Inspection of Brake
Adjust the clearance of the brake shoe so that
the left and right sides are even. Brake shoe
wears out gradually as the brake is used just
like an eraser. Check the remaining amount at
the inspection. Replace if it is too small.
Brake Drum Removal
Remove the tires.
Remove the bolts and then remove the
cover.
1
2
gw2sl9-001
Brake Drum Removal_001
1 Bolt
2 Cover
1.
2.
Loosen the special nut of the wheel motor
shaft.
Loosen the special nut a little, however do
not remove it.
1
2
gw2sl9-002
Brake Drum Removal_002
1 Wheel motor shaft
2 Special nut
Release the parking brake.
Install the gear puller to the brake drum.
Tighten the gear puller thread and pull out
the brake drum.
1
2
gw2sl9-003
Brake Drum Removal_003
1 Brake drum
2 Gear puller
Remove the special nut and spring washer.
Remove the brake drum from the plate.
2
1
3
4
gw2sl9-004
Brake Drum Removal_004
3.
4.
5.
6.
7.
8.
Main body
LM331
Main body
Page 6-15
Inspection and repair of each section